Imported electrical Exercisemost models that call us lawn mowers, Designed for a shearing of a gentle greenery growing on 
relatively level plot. However, this garden tool is often used to care for ordinary railway glades and roadside roads. And the first bottle or piece of iron fittings in the grass in the grass, lead to a breakdown of the most important part of the trimmer -catter with a fishing line. You can, of course, buy them regularly, but on this, understandable thing, goes and expensive during the season, and considerable money. My buddy, having embraced like trimmer breakdowns, I asked me to come up with something. At the same time noticed: "Not to aesthetics! The main thing is that the technique worked! "
First we fastened trimmer In the vice, turned on it and, substituting the coil of the coil to the remnants of the side walls, cut off the coil all unnecessary. (Decide to apply our experience, consider: during work it is necessary to protect the eye chips.)
It was necessary to adjust something to the plastic shaft. The buddy said that his neighbor was screwed into such a coil to such a coil with a thin stainless steel petals and now "rubit" everything. In my workshop there were tubes of a suitable diameter, washers and a slightly sheet stainless steel ...
With the help of discovers, we cut the petals of the knives of the required length (in the form of blades at the helicopter). The household welding machine was welded at three points to the tube of a suitable diameter of the washer. If you do not have the necessary washer, it can be made of sheet steel with a chisel and a round file. Then to the puck opposite each other (for the engine balance), knives were attached to the M4 screws, which for the reliability of the attachment glued with a hammer. Bakers were removed with a file, sharpened the blades.
The resulting design to the residue of the coil was put on (for fitting the tube on the shaft, it is convenient to cut the longitudinal strip of 2-4 mm long from it, then siege the hammer to the desired diameter) and combined with a copper pin, starting it with the passage. Holes for a pin is more convenient to drill around the place, after installing a new knife on the trimmer.
An hour later, we checked the work of the repaired aggregate on the lawn near my house. Tests of construction passed successfully - drew everything, and the buddy went to the "Posk".
I want to note that the design created by us turned out to be more efficient than the coil with a fishing line, but at the same time it is more dangerous. Therefore, it is better to work with her in protective shoes and away from people. It is also important to prevent the limit wear of petals and rivets.
Other interesting crafts:
Garden watches
Stands instead of a goat
Original fences for giving
Start a discussion ...