People came up with many interesting leisure and relaxation devices. Today we suggest you to make one of them - a suspension chair with your own hands. It is also called a flying chair or a swing chair. Swing in this cozy nest, you can build up, domestic and forget about your problems. You make sure the chair immediately It will become the center of universal attraction and in the apartment, and in the country. Therefore, not bag, proceed.
1. Now we will look at the original design of two hoops, braided with a cord in the style of Macrame. For it, the following materials will be required:
Two hoops from a metal-plastic pipe with a cross section of 35 mm. The hoop for the backrest diameter110 cm, the hoop for the seat -70 cm.
900 MPolimide cord thick4 mm. Ask the cord with a polypropylene core, creating dense nodes when viscating.
Locks -12 m.
Two thick cords for fastening both rings.
As for the sizes of the hoop, they can be made less, since the specified parameters are actually limiting for the suspension chairs. The entire volume of the cord is better to buy immediately so that there is no discrepancy in color and texture. Now that everything you need is harvested, you can proceed to work.
2. First we will determine the hoops. For each meter of the pipe goes on average P40 Mshnura. The turns should be laid tight, even with good tension. After every 20 turns, fasten the winding, pulling and spinning the last loops until it stops. The surface of the braid should be smooth and durable, because the mesh for the backrest and the seat will be attached to it. Work better in gloves.
3. Now right on the hoop double cord weave the grid, strengthened it to the braid double loop. Weaving scheme - the so-called chess, with flat knots. The ends of knots do not need to cut, of which the fringe will be formed. The elasticity of the grid depends on the strength of the tension of the cord when working. Possible deformation of the ring during a tight weaving is further compensated for by an equal tension of the nodes, and the shape of the hoop will be restored.
4. The next step is to fasten the braided rings in the chair. From one edge, clutch the hoops by durable winding with their cord. From the opposite edge insert two identical wooden rods. On all four ends, the rods are made of propuls, so that the hoops do not sculp. This will ensure the correct tilt of the backrest and will absorb the flat rigid grid for it. The length of the rod is set depending on the selected height of the back.
Schemes for weaving the back can be selected any. Who is engaged in Macrame, can choose any pattern. The cord is attached to the top of the back. The grid is inserted down to the seat. Cords are tightened on the lower ring. Lower residues are collected in the brush. The design is enhanced by two thick cords connecting the seat and the back. Slings attribute to the chair, and it takes its place in the garden, on the balcony or in the apartment.
but as the ends of the pipe between themselves to connect, m?