Stages of the house of the house Block House:
1. To begin, acclimatize a house, putting it on fresh air. Couples of the day will be quite enough. All spikes, grooves and panels themselves must be previously treated with an antiseptic.
All the necessary irregularities and roughness should be defined with the help of a special tool and reincarnate the panel with a solution, but before we recommend to look at the block House. The current antiseptic allows you to reach a variety of shades and ensure the protection of the Haws from the effects of ultraviolet radiation. The surface-spent surface does not require additional painting and varnishing.
2. Next, you should perform the walls of the walls. The crate is made using wooden bars that are attached to the wall by ordinary self-drawing. Bruks are fully suitable with a size of 30 mm by 50 mm, and they should be positioned at a distance of 60 cm from each other.
3. At the bottom, it is necessary to fasten the board at an angle of about 25 degrees to the horizon.
4. We start to sow a house from its lower part. The panel itself should be spiked to the top. The panel designed to cover the first row, like the bottom board, is cut under an angle of 25 degrees. Block House you need to firmly fit to the board and secure self-drawing. Withstanding a straight angle to the compound plane, a hole is dried to a depth of about 15 mm. The diameter of the hole must be made equal to the diameter of the heel. It is best to make bezel from birch. The heel itself must be made with a diameter of 25 mm.
5. In the well-done hole, sinks and close it with a heater. That part of the brazen, which will perform, should be cut, sand and paint in the color of the Haus block.
6. Installing all subsequent panels We carry out the usual way "Schip-groove". Further, at a distance of 60 cm, we perform the mounting of the Haus block with the help of screws.
7. Corners of panels are joking at an angle of 45 degrees or apply the corner board. If the wall is a little longer than the material to poisoned with the use of bar in thickness the same as the thickness of the panel. The angle performed in this way will look much more careful and better protects from the wind.
Start a discussion ...