Construction of a greenhouse

Such a greenhouse can make even an elderly person, one, spending the minimum of money (only to buy a film). They will need special building materials, only pieces of rubber, easily curved tube will go into the course (Cambridges can be used) and vine. Without a single nail, it turns out the tube (about 20 cm long) of the desired diameter and in the desired quantity. I cut the vines (with a thickness of a finger, a length of 1.5-1.6 m-optimally sewn of the film 3 m), cleaning from the bark, removing all sorts of sowers so that they do not fluff out. Thick ends of the vine are sharpening (they will then easily stick into the ground), I check thin, whether they come in the tube. Insert in pairs (two) vine into the tube on both sides, bend and get the first element - arc. Pretending their needingness, proceeding to the build of the frame. Ichoil the arches by pointed ends into the ground by 10 cm every 70 cm (how much allows the place for the greenhouse). For stability, fasten the arc with twine (see Fig.), Starting from the very top (C), then on the sides (A, B, D, E). The twine is fixed to the vine of the usual loop (only it should go down, if up - will sign the film). The ends tie him on the peg, drove into the ground at a short distance from one of the ends (which will like it) the greenhouse. It will be warmer do not forget: the construction of the greenhouse is like construction of houses than warmer, the better. As an "accessories", the pieces of cardboard slices (from some packaging boxes). They will be useful to protect plants from spring frosts (stitching inside the design of the greenhouse between the film and twine A and E, respectively, around the perimeter). Also, for heating, plastic water bottles are installed vertically around the perimeter: during the day they are heated by the sun, in the evening and at night - they give warmly. Fastening the film On the one hand, I buried the film into the ground, and on the other, I press bricks. Either (but then there will have to spend several tens of nails) one of the sides of the film along the very edge along the entire length nailed between two regions. In the future, holding for these rails as a handle, you can easily "manage" a greenhouse. Detail of the vine for the frame is better to take fresh, but it is possible to store in the autumn. In the latter case, arcs are made of pieces from the method described above and suspended in a curved form on a rope (hook) somewhere in the barn. It is impossible to nail the arc-vines!

A greenhouse from bottles. A buggy frame for a greenhouse can be made of plastic bottles. I collect "container" in advance (empty bottles of 1 l or 1.5 l from under lemonade or beer) and cut off the bottoms. In the first (1) cut-off "workpiece" I absorb the second (2) neck down, while at the same time riding them for subsequent fastening on the twine (3), etc. I leave the last bottle in this chain entirely, I only do a hole for twine. It then pulls out from the opposite ends (4) and tie. As a result, the arc should turn out (the size depends on the amount of bottles). The ends of the arc close in the soil, after about 0.8-1 m, placing the second arc, the third ... (for the length of the bed). I associate their sword (from above and on the sides), and the ends strengthened on the seals, driven by the center of narrow edges of the Grocery. Then I throw the film on the frame and close it with the edges of the soil.