How many strengths and funds we spent to repair the old house that was inherited by us: raised the foundation, changed the lower crowns, changed the interior design of the houseBut when they removed the trim from the facade - the gift of speech was lost! Under the windows there was no living place: Rinel did his trumpet. What to do? But here the father learned how to make a "fur coat" for the house, and we embodied it to life, however, with minor changes.
Make a mixture: 0.5 liters of gypsum on ten liter bucket of large sawdust. You need to pour it into the container, mix, then add approximately two liters of water.
Must get a wet crumbly mixture. But it can harden if it is not used immediately, therefore, before you do, you first need to prepare a formwork.
On the wall of the house, rails or bars are nailed, depending on the desired thickness of "fur coats", at a distance of 1 meter from each other (pre-prepare non-screensing boards for formwork). Sick them need from below.
Bookmark the mixture: 1/3 from the width of the board, tamper by repoks before the appearance of a characteristic clutch sound - this means that it is time to move to the second board and make the next bookmark.
Until all the subsequent - the first is hardening, and you can lay on it, and so on, to the very top. The formwork rises into four boards - the bottom you can rearrange. Thus, you can hip the old logs, and insulate the thin boards. Bruks and rails remain in order to then attach the skin to them.
In the photo the facade of our house after the removal of the formwork. The result is visible at once: when the "fur coat" dried, the house was transformed, it simply not to know. It was back in 2003, and for the past seven years "Shuba" is saved our new facade from bad weather, and we are from the cold.
House in "Shube"
Still on this topic
Comments leave a comment
Start a discussion ...