Mineral wool is one of the main types of insulation. It is an excellent insulation of walls and communications.
For a "wet" method, rigid stoves of standard size are used.
(preparatory process)
The outer surface of the building is purified from dust and dirt. If there is an old stucco, it must be deleted. After that, the processed area with deep penetration is primed. It will be better if you make a plan of future work. Back there, write down all the upcoming measurements.
Now you need to make cheers. This is done as follows: iron pins are scored on top and bottom, and the vertical cord is tight between them. Also done on the opposite side of the surface and horizontally. The distance between the thread and the surface is 55-60 mm. It will not be superfluous and diagonally. Take a ruler and, applying it strictly perpendicular to the wall, flush along the cord all the surface. Write down and compare these readings. In the future, focusing on the entry, you will know exactly where the plane is smooth, and where the sweep pan.
(mounting)
Put the plates on a flat surface, and apply special glue for mineral wool on one side. The adhesive solution should be applied with a toothed spatula. Leave them for a while, but for now install the horizontal base profile. To do this, output the zero mark of the lower part of the base. Stay under the profile of the front grid strip so that it spoke to below 25-30 cm. Secure the profile with steel dowels. Similarly, treat the angles by setting the design vertically.
Go to the laying of the lower row of the insulation, wrapping on it below the grid. All seams should not be more than 3-5 mm, otherwise it will be warm through them. Additionally, each slab fix the breakdown dowel (6, 7 pieces per 1 m?). Hat deepening. Close the spa.
In the next step, we welt the outer surface with a thin layer of glue. Pulling on top, stretch the mesh down, having it slightly in the adhesive layer. The joints must fall with at least 10 cm. Then again we welt glue.
After that, the entire surface is thoroughly ground and plaster. Stucco, maybe simple or decorative. A stunning effect gives granulated plaster.
The resulting example is a high-quality monolithic finish. The insulation material is not subject to the destruction of rodents. This method has a long life.
Wall insulation inside with their own hands
What is an eclaw and where it applies
Start a discussion ...