Modern building technologies are capable of any state of housing - to turn into an excellent design project. The main criterion of comfort in the house was all warm and good heating in the cold season.
But not all houses or apartments are able to boast such an indicator. In order not to freeze and avoid excessive dampness in the house - you should simply insulate the walls in your housing. To date, it is easy and easy to do with the help of an ordinary set of tools and foams, many interesting details about the insulation of the walls of the house can be found here - http://vlad172.ru/utePlenie-ten-doma/http-vlad172-ru- 1126.
Of course, such insulation slightly narrows the boundaries of your housing, but for the sake of a comfortable stay can be sacrificed. Moreover, the walls are easily and high quality can be insulated with conventional layers of foam width of just 5 centimeters.
In addition to the layers or rolls (different packaging) of the foam, you need special dowels, 2-3 bags of plaster mix (it is necessary to calculate the square of the room), mounting foam and putty for embedding seams.
It should be started from the floor and introduce the top in a checker order. To begin with, the sheet is applied to the wall and drown with a simple pencil. Following it is treated with the adhesive basis and applied to the drawn area. All squares should be checking the construction level all the time and follow the common wall geometry.
If the foam is very much sold in the walls, it can be fixed using a conventional spatula. The glued foam dries up and after that its seams are slightly expanding with a knife. After the work done, the seams are neatly treated with the mounting foam, the excess of which can be easily cut off the stationery knife. All the cracks near the floor and walls are sealed with a putty of plaster.
Let's give the whole design night for drying. After that, the entire foam is fixed around the perimeter of pre-prepared mushroom dowels with a drill. One sheet should leave two such dowels. Work tools should be very careful not to damage the integrity of the wall of the foam. After completing all the work, do not forget to treat dowels with putty. The finished insulated wall can be primed and hugged with wallpaper. Good repair!
What is an eclaw and where it applies
Selection of heat insulation for roofing
Start a discussion ...