Process the insulation of the facades of the foam Consists of several stages.
1. Preparation of the surface.
Before proceeding with warming, it is necessary to level the walls, that is, plastering, and then primed a special primer, which is intended for external work.
2. Print foam to walls.
To begin, it is necessary to attach the starting profile, which is intended to align the plane on the basement, as well as to hold the 1st row of foam.
Foaming is mounted with dry mixtures that are specifically designed for fastening foam to the facade.
For a start, the mixture is poured with water, mix the drill with a miksser nozzle, until a homogeneous mass is obtained, then stirred once again after 5 minutes and it is possible to stand in an hour and a half.
Installation of foam sheets need to be taken up, exposing the first sheets on the starting profile. During the installation, the sheets of foam are recommended to put the "brickwork" to avoid cracking. The gap between sheets should be minimal no more than 2 millimeters. So that there is no cold between the slits, otherwise the insulation will not bring the desired result.
3. Fastening foam.
After driving the glue to which you admired the foam, you can start foaming foam. To do this, it is best to use the thermal tube that should be with a plastic carnation.
To do this, drill holes in the middle and on the sides of the sheet and paste into the hole of the thermal tube, and then drive the nail.
4. Reinforcement of foam.
Reinforcement of foam, is performed to protect the surface of the foam. To do this, they are applied and strengthened on the surface of the foam, the insulation of reinforcing glass equipment, facade reinforcing mixtures, which are intended specifically for these purposes. To begin with, we apply a layer of the reinforcing mixture (up to 2 mm), and then put the reinforcement fiberglass. And then on top of another layer of the amicing mixture (up to 3mm). After drying, you need to remove unevenness and proceed to the final stage.
5. Finishing work.
To begin, it is followed to predict the surface of a special primer intended for this type of work, and then perform the final finish of the facade by any finishing materials, or just paint.
Well, here are all the stages of the insulation of facades of the house with foam.
We recommend our popular materials:
Than to separate the facade of a brick house
Drawing insulation of walls at home
Start a discussion ...