Any chair over the years comes in disrepair. The upholstery wipes, rushes; The seat is pushed, cracks; The legs and the back are loosened.
But this does not mean that it is time to get rid of such furniture, because it can be easily and just repaired. The main thing is to know how to do it, and if you doubt, contact here - repair of upholstered furniture.
To do this, you will need:
Furniture stapler for fastening fabric.
Scissors for trimming fabric.
Fabric and foam.
Plywood with a thickness of 6 mm, sizes 50-50 cm.
A small wooden bar needed for the manufacture of the base under the seat.
Varnish.
Sandpaper.
Saw or electrolovka.
Screws on wood.
Glue.
Dismantling and lacquer
First of all, they remove the upholstery of the chair, both with the back and from the seating. After that, they estimate, in what condition is a varnish coating. If the scratches and scratching are visible on it, the chair should be sanded and put several layers of varnish on it (at least 2). The subsequent layer is applied only after complete drying of the previous one.
By updating the lacquer frame, go to the restoration of the seating or manufacturing a new one.
Repair of seating
Stool seat is an element that breaks most often. The benefit that it can be easily restored.
To do this, take a piece of plywood, a thickness of 6 mm or more and with the help of an electric bike or saws scold the desired piece.
Now, the blank is applied to the discharged size (foam rubber). Its dimensions should be slightly larger than the scene itself. After that, the foam rubber is covered in advance sliced \u200b\u200bpiece of tissue and wrapped it under the bottom of the seating. The edges "grab" with a furniture stapler.
Foundation for seating
For the manufacture of the base, it will take a wooden bar with a thickness of 3-5 cm. Four triangles are cut out of it, on which the seat will be kept. After the manufacture, they are fixed in the corners of the chair. To do this, it is best to use screw screws.
If the chair is loosened
Disturbed legs and the back of the chair are another common problem.
To fix it, the rigging parts should be pulled out from the grooves and remove the remnants of the adhesive on them. After doing this, the desired amount of glue is applied with a special adhesive syringe in the grooves, and legs are inserted. Drying time can be different and depends on the type of glue.
On this, the repair of the chair is completed with their own hands. As you can see, it is quite simple and does not require any specific knowledge and talents.
In the article about a basket of newspaper tubes, you will find an interesting way to design a chair, for example, a flower and TP., Look here - Chair braided with newspaper tubes.
Start a discussion ...