How to choose the perforator to buy for home and prevent errors?
Before you begin the choice of perforator for the house, it is necessary to pay attention to at all the functionality of such equipment.
So, many modern perforator models have a special built-in depth gauge of the drilled hole. But it defines only to decide how best to achieve the desired depth, drilled hole.
Each perforator can operate in one or another mode provided, specifically for which they are equipped with special switches. They allow you to choose a special mode of operation of the product, and thereby controlled the speed of rotation of the booster and the effectiveness of the work performed. And therefore, in the case of drilling a large hole, it is recommended to perform work in slow rotation of the bora.
If you need to make a small hole, then the speed can be significantly increased by going to another mode of operation. A convenient function of reverse rotation provides the ability to pull the drill without much difficulty. And after that you can restore your work again.
The main technical characteristics of the perforator:
- Power. Remember that the greater the power will be, the higher the speed of rotation of the bora. In addition, the thickness of the borax also depends on the power of the device.
- Convenient adjustment of the speed of rotation. This element is available in almost all existing perforators. Very convenient is the speed adjustment program, especially during operation on the highest speed. In fact, it may look approximately like this: after installing the maximum speed, it remains to simply press the gay until it stops and simply perform the necessary works.
- Disabling shock ability. If the shock function is not turned off for a certain reason, it is not possible to use the perforator as a drill. The fact is that in the perforator the function of the drill is as secondary.
Replacing wiring in the apartment
How to deepen the well in the country
What to choose a perforator for home
Still on this topic
Comments leave a comment
Start a discussion ...