Make a well with your own hands is not such a tricky deal with such work quite cope with a brigade in the amount of 3-4 people.
For drilling, any drilling auger is suitable for manual drilling with extension pipes. With some alterations in the design, even the borrow is suitable for drilling ice. After preparing the bora, the pipe is prepared, which will be subsequently installed in a bored well.
To install in the well, any metal or plastic tube with thick walls is suitable. Returning from the end of the pipe is about 50 cm. On the entire surface of the pipe about one meter chop the holes with a drill of 6 mm. If the holes are more than 6 mm, then you will have to install the filter element in the pipe. The guide for centering is also installed on the pipe when installed in a well.
Drilling starts with a definition of a place for a well. After determining, the place is cleaned and removed the upper layer of the Earth by about 20-30 cm. Install a tripod with a winch to facilitate the auger lifting from depth.
At the beginning, the boring can be forged on the very handle with the subsequent buildup of the knees, but in the future the bee scroll up to ten times and pulled out to the surface for cleaning. When the drum on the solid soil is poured into the well for softening the soil solid. The most responsible moment will be with the approach to the aquifer. In this case, they scroll up to 5 times and remove for cleaning. Special attention should be paid to the fact that when approaching the water layer, the boring will be sucking and it can become so that stretching out of the well will be very difficult even with the winch.
After the well is drilled immediately need to insert pipes, the joints of the pipes are welded or twisted by specially prepared wide clamps. Due to the guides, the pipe is installed in the center of the well. The free space between the pipe and the walls of the well fall asleep with small gravel and soil. In the future, the deep pump is spent the wells of the well.
Start a discussion ...