Warming houses from a bar.

Last year we built house from Bruus 150 × 150 mm (attic also serrated). We want to do finish. The walls of the room floor we want to hamper with non-fatty plasterboard and go to wallpaper. In the factory kitchens purchased just a stunning kitchen, and the kitchen room also want to sheathe

non-fatty plasterboard. What kind of material should be paved between plasterboard and bar? Outside the house will be sidewged. What should the material be paved between siding and a bar? In the bathroom on the floor, we want to put the tile, how to prepare the floor for this?

First of all, you would like to note that you have a good opportunity not only to bind the house, no heat, do not miss this chance. And now I answer questions. Between the internal plasterboard plates and the timber should be laid a steamproof membrane.

Its role is to eliminate moisture penetration into wall material. Indeed, if moisture gets into the log in the latter, thermal resistance is significantly reduced. As such a membrane, one can advise unilaterally foolen foam foam. It has not only a foil surface, but also a small (4-10 mm) thermal insulating substrate. Note that this material is stacked by foil inside the building.

It not only blocks the path of saturated moisture air, but also further reflects the radiant energy coming from heating devices. Use special tapes for gluing foam sheets. Moreover, itching should be extremely conscientious, eliminating the slightest possibility of penetration of internal air through a steamproof surface.

Now about outdoor facing. Perfectly heat the brusade house Plates (mats) from stone wool, like Rockwool. If you launch a layer of 50 mm, then you really come close to modern standards for thermal insulation, and if 100 mm - will begin to significantly save in winter on the cottage heating. Over the thermal insulation layer, the windproof, waterproofing membrane is laid. By the way, the film must be laid in any case, even if you refuse additional insulation. Siding is mounted on guide metal profiles installed in parallel walls.

The simplest version of the flooring in the bathroom is to put the moisture-resistant phanener with a thickness of 20 mm in two layers, with dispersed on sheets. And on the top sheet, glue with parquet, glue floor tiles. Of course, the seams between the tiles should be conscientiously lured by hydrophobic grout. Let it offer you along the way to make a warm floor in the bathroom. Now, high-tech shoulder shoulder floor floors appeared on sale, which are stacked directly under the tile. Include it will only at the time of staying in the bathroom, the electricity will not "heat up" much, and the comfort of water procedures will noticeably increase.

It consumes about 30-40 W per m2. All the energy on the floor heating of the bathroom will be comparable to 2-3 electromagues.