An independent installation of the intercom in the apartment is quite complicated, but quite performing the task, the main thing is to accurately follow the installation instructions.
By the way, the independent installation of the intercom will help you save a completely small amount of money.
In apartment buildings, most often establish ordinary intercoms consisting of a bar desk and tube Read more Read on this page. In the elite cottages, video phones are often installed, the installation procedure of these two devices is about the same, they differ in just a few points.
Initially, why it should be started, of course, the preparation of the workplace and the necessary tool.
It is convenient to install the intercom near the entrance door, where you will be well audible from anywhere in the apartment.
So, proceed to the installation process:
The hardest, and that will take the most time, it will be the laying of wires. We will lay out from the door of the entrance, where the intercom is located, to the doors to your apartment, they will pass through the power shield, which is in the entrance on each landing. The wire will need to be paved inside the wall, for this you need in the wall using a drill and a special nozzle, punch the channels with a diameter that coincides with your cable that you need to pre-put the pipe corrugation, this is a special insulating tube. It should also be traced so that there are no freshers and cable saving. After the cable is placed inside the channels, they will need to smell alabaster.
The apartment will not need to spoil the walls at all, instead you need to use the plastic cable channels. They are paved along the door frame, such channels are superbly hiding any wires.
The testation and simpler stage will be the installation of a subscriber tube. To do this, on the estimated area of \u200b\u200bthe pipe, we make markup, then we drill in the wall of the hole and insert wooden leafy, well, or special plastic plugs. Self-tapes will be screwed into these traffic jams on what the subscriber tube will be held.
The final stage of work, checking the intercom. If your intercom executes all the functions, then you did everything right. Good luck!
Start a discussion ...