The most common method vintage grapesit is considered the coherence of the weeds. This requires well-developed and rided cuttings, a substrate (loose, moisture-holding soil), heat and light. But it is difficult to maintain 
Make such an "incubator", in general, easy. You will need a stainless steel mesh with a cell of 1 × 1 mm. We make a metal cylinder with a diameter of 20-30 cm and a height of 30-40 mm and another cylinder of a small diameter (so that it is freely inserted inside the first 
With a gap in two thickness of the grid) and a height of 150-160 mm. At this small cylinder stretch the grid of stainless steel. The grid must be gratened with wax.
Small cylinder with stretched grid insert into large. Attach the cylinders to each other in three points with screws or rivets. At the bottom of the wall we make a slot for the rubber tube.
Ready "double" cylinder put into the container a little more diameter, but the same height. We take a rubber tube with a length of 30-50 cm and a diameter of 6-10 mm. One end of the tube is set by the air divider made from the grid trimming. To do this, we turn the trim into the tube in two or three layers and put it on the rubber tube. The second end of the divider is flattened. On the other end of the tube we wear a rubber pear. Insert the tube with the tip into the slot to the grid.
In the cylinder, we put the cuttings, pour boiled water to a level of 10-15 mm above the mesh and with the help of pear with a heating air. Water poured as needed, air pumping 2-3 times a day. I noticed that in water enriched with oxygen, the cuttings are cursed easier.
I cut the cuttings so that there are two kidneys on each, I put the cuttings into the container of oblique cuts in one direction. After 10-12 days, I watch whether the roots appeared, and if they appeared, I carry out the extra-corner feeding of the Kemira-\u003e Lux at the rate of 0.5 g per 1 liter of water. The cuttings with the roots with a length of 3-5 mm are ready for landing in a plastic glass. On "After-incubation", the growing is required for 2-3 weeks.
On a note:
Investment in overseas real estate To date, it became very popular among Russians, since this procedure for buying an apartment or house abroad is extremely simple, and the cost of housing is sometimes much cheaper than buying real estate in Russia. Therefore, more and more of our compatriots invest their investments in the houses, apartments and plots.
Start a discussion ...