How to care for acrylic bath

Acrylic baths are comfortable, practical, durable and externally attractive. Lifecycle and appearance directly depend on the correctness of the care. Therefore, at the stage of the choice of the bathroom, it should be taken into account, for which it will be intended, besides its direct function. If you have to wash in the bathroom dishes, wash in basin baby clothes, if you often paint your hair at home, and not in a hairdresser, if you like to take a bath with a sea salt or extracts, if you have to bathe in the bathroom pets and, naturally, regularly Disinfect it with nothing else like a chlorine, then it is better to purchase an ordinary cast-iron bath. The main minus acrylic bath, with all its pluses, is that it can only be swimming in it, and for all other needs to adapt to another possible way.
Acrylic bathroom care implies the use of special cleaning products that do not leave scratches on the surface and do not enter into chemical interaction with acrylic. There are special care products for acrylic bathroom, but instead of them it is quite possible to use a conventional shower gel, baby soap, or washing powder. Prepare a soap solution and rinse the bath using a soft cloth, then rinse with clean water, wipe dry and soda polishing pasta to shine. Wash the bath need after each use.
Cleaning products for acrylic baths There must also be antibacterial, since the chlorine for their disinfection is not suitable. In order to treat a bath equipped with hydromassage, you need to dial water above the level of nozzles and add 1.5 liters of disinfectant or slightly less (recommendations in the instructions). Turn on the function of the hydromassage for ten minutes. Then dirty water is drained and the bath is typing again, turn on the hydromassage to wash the remnants of the means and drain water again.
How to care for an acrylic bath, if salt sediments and rusty leather appeared on it? You can remove them with a warm apple vinegar. Complete treatment from salts spend once a year. Water poured above the level of nozzles and 1.5 liters of a 7 percent solution of vinegar or citric acid are added to it. The bath must be turned on and left with this solution for 12 hours. After water to merge, fill the bath with clean water, turn on the hydromassage function. After that, the water is drained, the bath is wiping with a dry cloth and put the polyrolol.
If the detergents for acrylic baths do not cope with pollution, especially the spots can be removed by the most soft emery paper, at the same time treat it and small scratches. Then frosted places to lure the polyrolol. This board is only suitable for baths from cast acrylic.